Printer Error Codes
Has an error code appeared on your printer? We explain what it usually means and when you should call a technician. We repair printers of all makes. Shop in Ferreiras, Albufeira — we serve the whole Algarve.
Before You Contact Us
The meaning of a code can vary from model to model. In any case, these simple steps are safe:
- Switch the printer off and wait a few minutes.
- Check for jammed paper and remove it carefully, without forcing it.
- Switch the printer back on.
- If the code comes back, note it down together with the make and model, and contact us. Do not open or force the equipment.
Brother
The most common messages and codes on Brother printers and multifunction devices.
- Print Unable ## or Cannot Print ## — mechanical fault. Switch off, wait a few minutes and switch on again. On some models, code 50 indicates a fuser fault.
- Drum End Soon / Replace Drum — the drum is near the end of its life or has already reached it.
- Belt End Soon / Replace Belt — the same, for the belt unit.
- WT Box End Soon / Replace WT Box — the waste toner container is almost full or full. We replace the container.
HP
The most common codes on HP laser printers.
- 50.x (for example 50.00) — fuser error, related to temperature or heating. Switch the printer off for at least 30 seconds before switching it back on.
- 49.x — critical firmware error. Switching off and on again, and updating the firmware, solve some cases.
- 79 Service Error — usually related to the firmware or the formatter board.
Canon
The most common codes and messages on Canon printers and copiers.
- 5B00 — the waste ink absorber is full (inkjet printers). It is not a part the user should replace: it needs a repair.
- Waste toner container full — we replace the container.
- E000 — abnormal fuser temperature (copiers and laser printers).
- E014 — fuser motor fault.
- E202 and E225 — scanner fault (home position or light level).
- E240 — communication error with the controller.
Epson
The most common messages and codes on Epson printers.
- Maintenance box full — the printer stops to prevent ink leaks. We replace the box.
- Parts inside the printer have reached the end of their life (ink pads) — this is an internal part that needs a repair.
- 0x97 — internal fault in the equipment. It normally needs a repair.
Kyocera
The most common codes on Kyocera printers and copiers.
- C6000 and the rest of the C6xxx series — fuser fault (heating or temperature).
- C2000 — drive motor fault.
- Codes that start with C or F are service codes: a technician is needed.
Can't find your code?
Tell us the make, the model and the code shown on the display. We repair printers of all makes, on site, remotely or with collection and delivery.
